Low Prices! Largest Selection! Best Service!
|
Need
Help? |
FAST
& FREE SHIPPING
(on most items)
|
No
Illinois Sales Tax For Orders Outside Of IL |
ORDER
ONLINE OR CALL OUR FRIENDLY SALES STAFF TO PLACE AN ORDER BETWEEN 7:30am
& 4:30pm CST MON-FRI.
Toll Free: 1-877-925-5132 Most orders placed before 1:30pm CST will be shipped the same day.
Toll Free: 1-877-925-5132 Most orders placed before 1:30pm CST will be shipped the same day.
Septic
Solutions, Inc. has these Housings and Platforms manufactured specifically
for the SepAerator. They are roto-molded plastic products that are
designed to last many years sitting outside in various weather conditions.
These products will withstand the strong Ultra-violet rays of the
sun, extreme hot or cold weather, as well as keep your air pump out
of rain or snow. The Platform has plenty of bracing underneath ensuring
whatever heavy air pump is placed on it will not cause it to bow or
sag. The Platform also has in each of the 4 corners a small area that
extends ¾ of an inch above the base where the Housing attaches.
This is part of the design to allow plenty of air to flow between
the Housing and the Platform. It further allows for any water or snow
that might get inside to escape. At both ends of each Housing are
2 eight inch aluminum vents for additional ventilation. One of the
most important things anyone can do to protect their investment in
a new air pump is to make sure that air pump does not run to hot.
Inadequate ventilation can and will cause pre-mature failure of any
air pump. The SepAerator Housing and Platform was specifically designed
and built for the sole purpose of protecting and ventilating our air
pumps The Housing has curved edges and a rolling curved top, which
adds significantly to its strength. These curved features make the
molds much expensive to build than square or flat surfaces but when
you see the product we know you’ll agree it was well worth the
extra expense.
The
SepAerator uses only top quality air pumps that are designed and proven
to run trouble free for many years. These air pumps are both UL Listed
and CE Approved. They also come in a weatherproof housing meaning
that you could actually just sit these pumps outside and the weather
conditions would not affect them, however we highly recommend they
sit in our Vented Housing and Platform as described above. Our most
popular air pump is the Hiblow pump that was designed to run 24 hours
per day and based on our 7 years experience with these pumps run for
approximately 5 years before the diaphragms would need to be replaced.
Naturally Septic Solutions, Inc. has those replacement parts for sale
on our www.septicsolutions.com website for approximately $100. They
are easy to change and once changed the Hiblow pump should run another
4 or 5 years trouble free. We also offer Medo Piston pumps on some
of our packages, which are also tested and proven to run in the 5
year range trouble free. At that time the pistons can be replaced
for about the same price as the Hiblow parts and can also be found
at our above website. The Air Pumps are the workhorse of any aerobic
system and serious consideration should be given to the type of air
pump coming with your conversion equipment. There are many cheaper
air pumps available but it has been our experience that some of these
cheaper pumps experience diaphragm failure within the first 2 years
of operation. Both the Hiblow and Medo pumps, based on our 20 years
experience in the aerobic industry are by far the best. They do come
in different sizes and can be sized to fit just about any specific
application. Whether it is an average home or a large campground handling
many thousands of gallons of wastewater per day a SepAerator package
can readily be designed to fit your needs. Call our experienced staff
for any questions. 217-925-5992 
The
SepAerator™ Wonderfuser diffuser assembly performs multiple
tasks. First it self-positions itself and sits solidly on the bottom
of the septic tank ensuring that the air is introduced at a consistent
height inside each and every septic tank. The Wonderfuser was purposely
designed to be very heavy on the bottom and lightweight on the top.
This means that the top is buoyant and when lowered into a septic
tank full of effluent. Even on its side, once it touches the bottom
the top will want to float up while the base remains firm on the bottom
of the tank. This action actually causes the Wonderfuser to stand
upright and in the position it must be in to operate correctly. No
need to worry about getting it just right as it will by design work
itself into the proper operating position. With a heavy base weighing
approximately 12 pounds or more it cannot do anything other than stay
in the proper upright position. 
The
spa-flex air line is made up of a very high grade material that is
very strong and flexible. Its flexibility allows for easy installation
in even the most difficult of circumstances. Simply screw the threaded
adapter we send already attached to the air line into the fitting
already installed in the top of the diffuser. Lower the diffuser into
the tank using the spa-flex and even swing it over into position if
necessary. Curve the line up through the opening and out the side
and then up and into the bottom of the housing where the other end
hooks to the air pump. It cannot be much easier than that. This spa-flex
can be glued to ½ schedule 40 pvc pipe if you want to extend
the pump to a remote location. It is extremely tough and durable ensuring
that it will deliver air from the pump to the diffuser trouble free
for many years to come.
As
mentioned in the prior Diffuser information the SepAerator™
will rapidly break waste solids down into small particles. In order
to produce the cleanest effluent possible the SepAerator™ Premium
Package comes with our patent pending Air Particle Recirculator. The
aforementioned small particles that are moving around in the septic
tank will naturally float towards the discharge area. The Recirculator,
which consists of a 6 inch filter assembly, large fiber filter, and
an air diffusion system located just above the inlet, will eliminate
any of those particles from discharging into the secondary treatment
system or pre-maturely clog the filter. 
